Poly-Vinylidene Fluoride (PVDF)/ Span-85 Membrane for Omega-3 PUFA Concentration: Membrane Performance and Fouling Analysis

Authors

  • Samaneh Ghasemian Department of Food Science and Technology, Faculty of Agriculture, Tarbiat Modares University, P.O. Box: 14115-336, Tehran, Iran
  • Mohammad Ali Sahari Department of Food Science and Technology, Faculty of Agriculture, Tarbiat Modares University, P.O. Box: 14115-336, Tehran, Iran
  • Mohsen Barzegar Department of Food Science and Technology, Faculty of Agriculture, Tarbiat Modares University, P.O. Box: 14115-336, Tehran, Iran
  • Hassan Ahmadi Gavlighi Department of Food Science and Technology, Faculty of Agriculture, Tarbiat Modares University, P.O. Box: 14115-336, Tehran, Iran
  • Reza Abedini Faculty of Chemical Engineering, Babol Noshirvani University of Technology, P.O. Box: 484, Babol, Iran

DOI:

https://doi.org/10.15379/ijmst.v10i1.1070

Abstract

Abstract: For increasing the efficiency of the omega-3 production, the effect of span-85 surfactant as a hydrophobic agent (0, 1, 2, 3 and 4 wt%) on the formation of a porous structure in a sub-layer PVDF membrane was studied. Also, the cross-sectional morphology of PVDF membranes was analyzed using scanning electron microscopy (SEM) and the surface property was evaluated using contact angle test. The capacity of the membranes to concentrate omega-3 was examined by the filtration of lantern fish oil. Also, the fouling of the membrane caused by oil filtration was evaluated. All filtration tests were performed in batch mode. Results of the SEM images demonstrated that the addition of span-85 resulted in the forming of a membrane with a denser and more hydrophobic structure. The addition of 2 wt% span-85 increased the omega-3 concentration, while the higher level of span-85 showed a negative effect. The best efficiency of the membrane was 42.64 wt% which was obtained by PVDF/2 wt% span-85. This efficiency was about 11% higher than the control PVDF (0 wt%). Taken together, the presence of span-85 affected the phase inversion process during the membrane formation, which improved omega-3 concentration. Moreover, the more hydrophobic surface of the membrane resulted in higher cake formation.

Keywords: Omega-3 PUFA, Poly-vinyldene fluoride (PVDF), Membranes performance, Span-85, Concentration, Fouling analysis.

Downloads

Download data is not yet available.

References

Ackman RG (2006) Losses of DHA from high temperatures of columns during GLC of methyl esters of long-chain omega-3 fatty acids. J Am Oil Chem Soc 83:1069-1070. https://doi.org/10.1007/s11746-006-5164-1

Feltes MMC, Oliveira JV, Treichel H, Block JM, de Oliveira D, Ninow JL (2010) Assessment of process parameters on the production of diglycerides rich in omega-3 fatty acids through the enzymatic glycerolysis of fish oil. Eur Food Res Technol 231: 701-710. https://doi.org/10.1007/s00217-010-1325-4

Bravi E, Perretti G, Falconi C, Marconi O, Fantozzi P (2017) Antioxidant effects of supercritical fluid garlic extracts in sunflower oil. J Sci Food Agric, 97: 102-107. https://doi.org/10.1002/jsfa.7690

Kolanowski W, Laufenberg G (2006) Enrichment of food products with polyunsaturated fatty acids by fish oil addition. Eur Food Res Technol 222: 427-477. https://doi.org/10.1007/s00217-005-0089-8

Rodriguez NR, Beltran S, Jaime I, Diego SM, Sanz MT, Carballido JR (2010) Production of omega-3 polyunsaturated fatty acid concentrates: A review. Innov Food Sci Emerg Technol 11: 1-12. https://doi.org/10.1016/j.ifset.2009.10.006

Homayooni B, Sahari MA, Barzegar M (2014) Concentrations of omega-3 fatty acids from rainbow sardine fish oil by various methods. Int Food Res J 21: 743-748.

Linder M, Matouba E, Fanni J, Parmentier M, (2002) Enrichment of salmon oil with n-3 PUFA by lipolysis, filtration and enzymatic re-esterification. Eur J Lipid Sci Technol 104: 455-462. https://doi.org/10.1002/1438-9312(200208)104:8<455::AID-EJLT455>3.0.CO;2-Q

Abedini R, Mousavi SM, Aminzadeh R (2012) Effect of sonochemical synthesized TiO2 nanoparticles and coagulation bath temperature on morphology, thermal stability and pure water flux of asymmetric cellulose acetate nanocomposite membranes prepared via phase inversion method. Chem Ind Chem Eng Q, 18: 385-398. https://doi.org/10.2298/CICEQ111202014A

Hosseinzadeh Beiragh H, Omidkhah M, Abedini R, Khosravi T, Pakseresht S (2016) Synthesis and characterization of poly (ether-block- amide) mixed matrix membranes incorporated by nanoporous ZSM-5 particles for CO2/CH4 separation. Asia-Pacific J Chem Eng 11: 522-532. https://doi.org/10.1002/apj.1973

Ghasemian S, Sahari MA, Barzegar M, Ahmadi Gavlighi H (2015) Concentration of omega-3 polyunsaturated fatty acids by polymeric membrane. Int J Food Sci Technol 50: 2411-2418. https://doi.org/10.1111/ijfs.12907

Abedini R, Omidkhah M, Dorosti F (2014) Hydrogen separation and purification with poly (4-methyl-1-pentyne)/MIL 53 mixed matrix membrane based on reverse selectivity. Int J Hydrogen Energy 39: 7897-7909. https://doi.org/10.1016/j.ijhydene.2014.03.027

Azmi RA, Goh PS, Ismail AF, Lau WJ, Ng BC, Othman NH, Noor AM, Yusoff MSA (2015) Deacidification of crude palm oil using PVA-crosslinked PVDF Membrane. J Food Eng 166: 165-173. https://doi.org/10.1016/j.jfoodeng.2015.06.001

Castro-Muñoz R, Yáñez-Fernández J, Fíla V (2016) Phenolic compounds recovered from agro-food by-products using membrane technologies: An overview. Food Chem 213: 753-762. https://doi.org/10.1016/j.foodchem.2016.07.030

Dorosti F, Omidkhah M, Abedini R (2014) Fabrication and characterization of Matrimid/MIL-53 mixed matrix membrane for CO2/CH4 separation. Chem Eng Res Des 92: 2439-2448. https://doi.org/10.1016/j.cherd.2014.02.018

Jamshidi M, Pirouzfar V, Abedini R, Pedram MZ (2017) The influence of nanoparticles on gas transport properties of mixed matrix membranes: An experimental investigation and modeling. Korean J Chem Eng 34, 829-843. https://doi.org/10.1007/s11814-016-0302-4

Dorosti F, Omidkhah M, Abedini R (2016) Enhanced CO2/CH4 separation properties of asymmetric mixed matrix membrane by incorporating nano-porous ZSM-5 and MIL-53 particles into Matrimid®5218. J Nat Gas Sci Eng 25: 88-102. https://doi.org/10.1016/j.jngse.2015.04.033

Abedini R, Omidkhah M, Dorosti F (2014) Highly Permeable Poly (4-methyl-1-pentyne)/NH2-MIL 53 (Al) Mixed Matrix Membrane for CO2/CH4 Separation. RSC Adv 4: 36522-36537. https://doi.org/10.1039/C4RA07030E

Ghasemian S, Sahari MA, Barzegar M, Gavlighi HA (2017) Omega-3 PUFA concentration by a novel PVDF nano-composite membrane filled with nano-porous silica particles. Food Chem 230: 454-462. https://doi.org/10.1016/j.foodchem.2017.02.135

Abedini R, Omidkhah M, Dorosti F (2014) CO2/CH4 separation by a mixed matrix membrane of polymethylpentyne/MIL-53 particles. Iranian J Polym Sci Technol 27: 337-351. https://doi.org/10.1039/C4RA07030E

Wang C, Li Q, Tang H, Yan D (2012) Membrane fouling mechanism in ultrafiltration of succinic acid fermentation broth. Bioresource Tech 116: 366 - 271. https://doi.org/10.1016/j.biortech.2012.03.099

Abedini R, Mousavi SM, Aminzadeh R (2011) A novel cellulose acetate (CA) membrane using TiO2 nanoparticles: Preparation, characterization and permeation study. Desalination 277: 40-45. https://doi.org/10.1016/j.desal.2011.03.089

Soloukipour S, Saljoughi E, Mousavi SM, Pourafshari Chenar M (2017) PEBA/PVDF blend pervaporation membranes: preparation and performance. Polym Adv Technol 28: 113-123. https://doi.org/10.1002/pat.3865

Ghasemian S, Sahari MA, Barzegar M, Gavlighi HA (2016) Omega 3 polyunsaturated fatty acids concentration using synthesized poly vinylidene fluoride (PVDF) asymmetric membranes. J Am Oil Chem Soc 93: 1201-1210. https://doi.org/10.1007/s11746-016-2876-8

Downloads

Published

2023-01-20

How to Cite

[1]
S. Ghasemian, M. A. Sahari, M. Barzegar, H. A. Gavlighi, and R. Abedini, “Poly-Vinylidene Fluoride (PVDF)/ Span-85 Membrane for Omega-3 PUFA Concentration: Membrane Performance and Fouling Analysis”, ijmst, vol. 10, no. 1, pp. 8-16, Jan. 2023.